How to Set Up Your Nolah Adjustable Base Without Help

Setting up an adjustable base often feels like a two-person job, but with the right approach, you can do it alone. Whether you’ve just purchased a LiftEase Adjustable Base or are planning to, this guide will walk you through every step of solo assembly. From unpacking to final positioning, we’ll cover the tools you need, safety precautions, and how to avoid common mistakes.

By following these instructions, you’ll have your base ready for your Nolah mattress in under an hour—without straining your back or damaging the components. Let’s get started.

Unboxing and Preparing Your Workspace

Before you begin, clear a large area in the room where you’ll set up the base. Remove any existing bed frame or box spring. Lay down a blanket or cardboard to protect the floor and the base’s fabric. The LiftEase Adjustable Base ships in a long, heavy box, so use a dolly or slide it carefully to avoid injury.

Open the box and verify all parts: base frame, legs, power cord, remote control, and hardware kit. Check for any visible damage. If something is missing, contact Nolah support. Keep the box and foam inserts until assembly is complete—they can be useful for returning or recycling.

• Tip: Have a Phillips head screwdriver and a socket wrench (or adjustable wrench) ready. Most bolts are pre-installed or require simple tightening.

Assembling the Base Frame Solo

Start by unfolding the base on the floor. The LiftEase Adjustable Base has a two-piece frame that hinges in the middle. With the base lying flat, attach the legs. Each leg screws into a pre-threaded hole at the corners. Tighten them by hand, then use a wrench to secure firmly—but don’t overtighten.

Next, connect the power cord to the control box and plug it into a wall outlet. Test the remote to ensure the head and foot sections move smoothly. If the base has a massage function, check that too. This is easier to troubleshoot now than after you’ve placed the mattress.

• Pro tip: Use a power strip with surge protection to keep the cord tidy and protect the electronics.

Positioning and Leveling the Base

Once the frame is assembled and legs are attached, carefully flip the base upright. Lift from the head end while supporting the middle hinge—this prevents strain. Walk the base to its final position near the wall. Most adjustable bases require a few inches of clearance behind the head for full articulation.

Use a level on the base rails to check if it’s even. Adjust the legs by twisting them clockwise or counterclockwise to raise or lower each corner. A level base ensures your mattress lies flat and prevents uneven wear on the foam layers.

• Safety note: Always keep the base unplugged until you’re ready to test movement. Avoid pinching cables under the base.

Placing Your Mattress and Final Adjustments

With the base locked in position, it’s time to add your mattress. If you’re using a Nolah Original or another Nolah mattress, unbox it on the floor nearby and let it expand for a few hours before placing it on the base. This prevents the mattress from sliding during setup.

Lift the mattress onto the base, centering it evenly. Use the remote to raise the head section slightly—this helps the mattress settle against the foot. Then lower it flat. Test all positions to ensure the mattress stays in place. If you have a mattress topper, add it after the mattress has fully expanded.

• Tip: For a complete sleep setup, pair your base with a Nolah Microcoil Mattress Topper for extra comfort and pressure relief.

Setting up your Nolah adjustable base alone is entirely doable with careful planning and a methodical approach. Take your time, use proper lifting techniques, and don’t hesitate to ask a neighbor for help lifting the base onto the frame if needed. Once assembled, you’ll enjoy personalized comfort and better sleep. If you haven’t yet chosen your base, explore the LiftEase Adjustable Base for its quiet motor and wall-glide feature—perfect for solo setup and daily use.